We perennially produce and export ASTM standard titanium bar and Chinese standard (GB) standard titanium bar, and titanium bar of mutually agreed standard.
Being one of the few manufacturers that can realize quality control on the whole production process, we execute strict quality control all the way from the raw material smelting of titanium sponge to the finished products.
Having premium quality and impeccable tracking and service, we sell products including medical titanium bar, titanium polishing bar and titanium alloy bar all over the world. We have become one of the biggest suppliers and exporters of titanium bar in China.
Size range
|
|
|
|
Gr1,Gr2,Gr2,Gr3,Gr4,Gr5,Gr7,Gr9,Gr12
|
|
|
|
|
|
|
|
Chemical Requirements
D Need not be reported
E A residual is an element present in a metal or an alloy in small quantities and is inherent to the manufacturing
process but not added intentionally.In titanium these elements include aluminum.vandium,tin,chromium,
molybdenum,niobium,zirconium,hafnium,bismuth,ruthenium,palladium,yttrium,
copper,silicon,cobalt,tantalum,nickel,boron,manganese,and tungsten.
F The purchaser may,in his written purchase order request analysis for specific residual elements not listed in this specification.
G The percentage of titanium is determined by difference.
Tensile Requirements
|
|
Yield Strength,0.2%Offset
|
Elongation in 2 in.or 50mm,min,%
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
C Material is identical to the corresponding numeric grade(that is,Grade 2H=Grade 2)except for the higher guaranteed minimum UTS,and may always be certified as meeting the requirements of its corresponding numeric grade,Grade 2H,7H,16H,and 26H are intended primarily for pressure vessel use.
D The H grades were added in response to a user association request based on its study of over 5200 commercial Grade 2,7,16,and 26 test reports,where over 99% met the 58 ksi minimum UTS.
E For Grades 5,6 and 32 the elongation on materials under 0.025in.(0.635mm)in thickness may be obtained only by negotiation.
F Flongation for continuous rolled and annealed(strip product from coil) for Grade 18 shall be 12%minimum in the longitudinal direction and 8% minimum in the transverse direction
|